Install VeriLock Security Sensor on Gliding Patio Door Without Exterior Keyed Lock |Andersen Windows

Install VeriLock Security Sensor on Gliding Patio Door Without Exterior Keyed Lock |Andersen Windows


This video will show you how to install
a Verilock Security Sensor on Andersen A- Series, 400 Series and 200 Series Gliding
Patio Doors without an exterior keyed lock. You will need safety glasses, a
Phillips screwdriver and a drill with a 1/8 inch bit, as well as, a Verilock
security sensor kit available from your Andersen dealer or parts.andersen
windows.com. Before you begin, find the accessory guide that came with your kit.
Be sure to read it completely including all the cautions and warnings. Magnets
are included in this kit, be sure to keep them away from electronics or implanted
medical devices as damage could occur. After selecting the Verilock faceplate
that best complements the decor of your door,
press the sensor into the backside of the faceplate. Insert the battery into the sensor with
the plus sign facing out as shown. Then position the Verilock actuator and
insert it into the hole in the faceplate as shown. Unlock and open the patio door. Remove the screws securing the thumb
latch and properly dispose of the screws. Then, remove the thumb latch. Next, insert
the thumb latch pin through the actuator slot on the sensor assembly as shown. If
you have Tribeca Hardware you’ll need to place one of the color-matched spacers
between the thumb latch and the sensor. Verify the panel surface is clean and
dry. Position the thumb latch and verilock sensors assembly on the panel
as shown and fasten using the screws provided. The indicator light will
illuminate when the sensor assembly is applied to the panel. Position the magnet
on the side jamb behind the weatherstrip tight to the interior edge of the lock
receiver as shown. Mark the position of the holes in the
magnet. Then remove the magnet. Using a 1/8 inch bit drill two holes, three
quarters of an inch deep at the mark locations
taking care not to damage the weatherstrip. Position the magnet over
the holes and fasten with the screws provided. Close and lock the door To verify the sensors operation, unlock
the door the indicator light will illuminate for
one second. It will illuminate again when you open
the door. When you close the door and finally when you lock the door.
Congratulations you have successfully installed a Verilock Security Sensor on
your Andersen Gliding Patio Door if you need parts for your Andersen windows or
doors just go to our online parts store at parts.andersenwindows.com. And if
you have questions about care, maintenance or repair call our customer
care center at 888-888-7020. Visit the Help Center and the service section of our website at help.andersenwindows.com. Andersen customer care is what we care about most

Leave a Reply

Your email address will not be published. Required fields are marked *